C2_W4 Assignment: I've read most of the forum posts about low accuracy issues, but none of the solutions are working

[Deepti_Prasad]

Have you tried this post, read all the comments, this should give you the solution

Training accuracy 86% validation 94%, required training accuracy 99% validation accuracy 95%

hey I referred the same post to clear assignment in the week 3, but I have doubt for this section. other than 2 conv2d and 2 maxpooling2d, I have used 2 dense layer. I didn’t include dropout. So in my last dense layer I used 26 units that’s where in one of the post you replied not to use, so I tried using 3, that when I get value error. I also did optimiser Adam first which still gave the same result. then I used rms-prop, which reduced the accuracy.

Regards
DP