Hello again! Unfortunately, I could not replicate the issue. The command ran normally and it was done creating the cluster in about 5 to 10 minutes. The screenshot below show that the environment variables were created and then I was able to execute the command you mentioned:
The only hiccup I encountered is Qwiklabs didn’t start the lab in the student account. I had to switch my profile to the email they gave. Please see the troubleshooting tip here for details.
If you retried the lab and the cluster creation is still not pushing through after 10 minutes. Please consult with the Qwiklabs agents using their support channels so they can check possible problems with your setup. The support channels are on the upper right and the chat option is usually responsive:
Hope these help and you’re able to proceed with the lab.